Ok took everything off, front wheel, calipers, pads, rotors, bearings, axle.
The front pads had some brake fluid on them from when I installed them. So I scuffed them up got all the glaze off, scuffed up the rotors, drained and flushed the resvoir, and repacked the bearings. I did a run out again. Put everything was perfect. everything tq'd proper. Also took a look at the calipers again cleaned them up more , everything checks out there. Anyway broke the brakes in again everything felt great at speed, but brakes pulsate now at very slow speeds. Talked to a tech. at atlantic cycle, said that air might be getting in between the rotor and pads where there is now rotor. The calipers ride up at the outer edge of the rotor where the wave is cut out. Does anyone think that might be an issue?