DCSportbikes.COM

Anyone ever had this issue..........

Any suggestions.........
 

I suggest you not install something that might facilitate impaleming you on your bike, especially when get-offs on motorcycles are an eventuality. Just a suggestion.

sooperman12:

I suggest you not install something that might facilitate impalingyou on your bike, especially when get-offs on motorcycles are an eventuality. Just a suggestion.

FIXED dang no edit button...

i HAD them.  make sure you use loctite when you put them on!  one of mine fell off and im back to stock till my new ones come in.  

i didnt have a prob gettin my bar ends off though.  take the center screw out and it should come off.

 Have you ever seen bar ends off on a bike and seen the design?

While turning figure # 5 figure # 8 is most likely turning as well. Figure # 7 is a rubber grommet that when compressed it will tightened up inside. Try getting 1/4 drive extension with the appropriate socket to hold figure # 8 while turning Figure # 5.

If that doesn't work, yank that biatch out while wigging it up and down and side to side.

Hope this helps.  

 Thanks yall..........  I will try this after work...............